Failure Analysis & Design Validation
Design Validation & Failure Analysis
In-house setups and third party services are offered for Validating Prototype Production and performing Failure Analysis.
- Short term and long term reliability tests to validate design, concept, process and material integrity
- Detailed visual inspections of failed parts
- Communicating with customers on process, design, material, and workmanship
- Performing non-destructive and destructive tests
- Reviewing test results, discussing findings with customers, and preparing final reports
Specific Services
- X-Ray imaging
- 3D Measurement/Inspection system
- Shear test – 50 gram F to 10 kilogram F
- Pull test – up to 50 gram F
- Fine leak check – Helium Mass Spectrometer, MIL STD 883, 750
- Gross leak check – up to 250℃
- Profile projector
- Z–Scope up to 40X
- Light engine test – up to 50 VDC, 3 A, 10℃ to 40℃
- X-Ray imaging
- 3D Measurement/Inspection system
- Acoustic imaging, SEM, EDS, metallographic cross sectioning, decapsulation, delayering, solderability, shock and vibration, resistance to solvents, and particle impact noise detection tests can be completed as required.
Consultative Services
- Emphasizing Quality
- Performance
- Cost Reduction
- Reliability
- Failure Analysis